Yamaha HTR-5920 Manual do Proprietário - Página 37

Procurar online ou descarregar pdf Manual do Proprietário para Recetor Yamaha HTR-5920. Yamaha HTR-5920 45 páginas. Digital home theater system av receiver
Também para Yamaha HTR-5920: Manual de serviço (38 páginas)

Imprimir página

Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below

or if the instruction below does not help, set this unit to the standby mode, disconnect the power cable, and contact the

nearest authorized YAMAHA dealer or service center.

General

Problem

This unit fails to turn

The power cable is not connected or the

on when STANDBY/

plug is not completely inserted.

ON (or POWER) is

The protection circuitry has been

pressed, or enters the

activated.

standby mode soon

after the power has

been turned on.

This unit has been exposed to a strong

external electric shock (such as lightning

or strong static electricity).

No sound

Incorrect input or output cable

connections.

The input mode is set to DTS or

ANALOG.

No appropriate input source has been

selected.

Speaker connections are not secure.

The volume is turned down.

The sound is muted.

The input mode is set to ANALOG while

playing a source encoded with a DTS

signal.

Signals this unit cannot reproduce are

being received from a source component,

such as a CD-ROM.

TROUBLESHOOTING

Cause

Connect the power cable firmly.

Make sure all speaker wire connections on this unit

and on all speakers are secure and that the wire for

each connection does not touch anything other than

its respective connection.

Set this unit to the standby mode, disconnect the

power cable, plug it back in after 30 seconds, then use

it normally.

Connect the cables properly. If the problem persists,

the cables may be defective.

Select AUTO.

Select an appropriate input source with

INPUT l / h on the front panel (or the input

selector buttons on the remote control).

Secure the connections.

Turn up the volume.

Press MUTE on the remote control.

Set the input mode to DTS.

Play a source whose signals can be reproduced by this

unit.

TROUBLESHOOTING

Remedy

Refer to

page

—

11, 12

—

13-16

—