Yamaha A-S3200 Manual do Proprietário - Página 7

Procurar online ou descarregar pdf Manual do Proprietário para Amplificador Yamaha A-S3200. Yamaha A-S3200 32 páginas.

Imprimir página

Remote control sensor

Receives signals from the remote control. (➔ page 14)

PHONES jack

Connect your headphones here.

Note

• Connecting the headphones here will result in the

following:

- No sound will be heard from the connected speakers.

- Audio signals will not be output at the PRE OUT jacks.

- You will be unable to select MAIN DIRECT as the input

source.

• If MAIN DIRECT is selected as the input source, audio

signals will not be output at the PHONES jack.

TRIM selector

Switches the headphone amp gain.

Select the gain setting that is appropriate for your

headphones.

Available gain:

−6 dB, 0 dB, +6 dB, +12 dB

SPEAKERS selector

Switches sets of speakers connected to the

SPEAKERS L/R CH A and B terminals on the rear

panel as follows:

OFF: No audio signals will be output from the

speakers.

A: Audio signals will be output from the set of

speakers connected to the A terminals.

B: Audio signals will be output from the set of

speakers connected to the B terminals.

A+B BI-WIRING: Audio signals will be output from

the sets of speakers connected to the A and B

terminals. Select this position when you plan to

make a bi-wired connection. (➔ page 19)

NOTICE

[Model for Asia]

If you connect two sets of speakers (A+B), use the

speakers with an impedance of 12Ω or higher.

[Other models]

If you connect two sets of speakers (A+B), use the

speakers with an impedance of 8Ω or higher.

METER selector

Switches the meter function as follows:

OFF: Turns off meter operation and display

illumination.

PEAK: Switches the meter display type to a peak

level meter. The peak level meter shows the

highest instantaneous level of an audio output

signal.

VU: Switches the meter display type to a VU (Volume

Unit) level meter. The VU level meter shows an

effective audio output value that represents the

way sound is perceived by human ears.

DIMMER: When selected, the DIMMER

automatically changes the brightness of the meter

display in steps. When you see the brightness level

you desire, switch to another setting parameter to

lock in the new brightness setting.

Meter (LEFT/RIGHT)

Indicates the audio output level of the left (LEFT) and

right (RIGHT) channels.