Clark Synthesis TACTILE SOUND AW339 Manual de instalação - Página 6

Procurar online ou descarregar pdf Manual de instalação para Transdutor Clark Synthesis TACTILE SOUND AW339. Clark Synthesis TACTILE SOUND AW339 20 páginas. All-weather transducer
Também para Clark Synthesis TACTILE SOUND AW339: Manual suplementar (4 páginas), Ficha de dados (1 páginas), Manual de instalação (8 páginas), Manual de instalação (2 páginas), Manual do comprador (2 páginas), Ficha de especificações (1 páginas)

Imprimir página

Installation: Overview

Installation Type: Unimount Bracket
Screws into the bottom of the mounting surface.
Requires access only to the bottom of the mounting
surface. Requires a flat or nearly flat mounting surface.
Minimum 4-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
3/4"-thick
mounting
surface
Unimount
Bracket
Flat Washer
Lock Washer
Screw
Jam Nut (up)
Transducer Lead Wire
6
Tactile Sound Transducers
NEVER TIGHTEN
BY TURNING THE
TRANSDUCER.
MAKE SURE TO
TIGHTEN THE JAM
NUT AGAINST THE
TRANSDUCER'S
BRASS NUT
3/8"-16
Threaded Stud
Jam Nut (down)
Washers
Screw
Jam Nuts
Installation Type: Hanger Bolt
Screws into the bottom of the mounting surface (into a
5/16" drilled hole. Requires access only to the bottom
of the mounting surface.
Minimum 3-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
Minimum
3/4"-thick
Transducer Lead Wire
Tip: Tighten
two Jam Nuts
against each
other to screw
in Hanger Bolt
using wrench.
Joist
(edge view)
Drill 5/16" hole
3/8"-16
Hanger Bolt
Jam Nut (down)
Jam Nut
www.clarksynthesis.com