Clark Synthesis TACTILE SOUND AW339 Руководство по установке - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке для Преобразователь Clark Synthesis TACTILE SOUND AW339. Clark Synthesis TACTILE SOUND AW339 20 страниц. All-weather transducer
Также для Clark Synthesis TACTILE SOUND AW339: Дополнительное руководство (4 страниц), Информационный лист (1 страниц), Руководство по установке (8 страниц), Руководство по установке (2 страниц), Руководство покупателя (2 страниц), Технический паспорт (1 страниц)

Печатать страницу

Installation: Overview

Installation Type: Unimount Bracket
Screws into the bottom of the mounting surface.
Requires access only to the bottom of the mounting
surface. Requires a flat or nearly flat mounting surface.
Minimum 4-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
3/4"-thick
mounting
surface
Unimount
Bracket
Flat Washer
Lock Washer
Screw
Jam Nut (up)
Transducer Lead Wire
6
Tactile Sound Transducers
NEVER TIGHTEN
BY TURNING THE
TRANSDUCER.
MAKE SURE TO
TIGHTEN THE JAM
NUT AGAINST THE
TRANSDUCER'S
BRASS NUT
3/8"-16
Threaded Stud
Jam Nut (down)
Washers
Screw
Jam Nuts
Installation Type: Hanger Bolt
Screws into the bottom of the mounting surface (into a
5/16" drilled hole. Requires access only to the bottom
of the mounting surface.
Minimum 3-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
Minimum
3/4"-thick
Transducer Lead Wire
Tip: Tighten
two Jam Nuts
against each
other to screw
in Hanger Bolt
using wrench.
Joist
(edge view)
Drill 5/16" hole
3/8"-16
Hanger Bolt
Jam Nut (down)
Jam Nut
www.clarksynthesis.com