Clarke 6462180 Manual de Instruções de Operação e Manutenção - Página 8

Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Ferramenta eléctrica Clarke 6462180. Clarke 6462180 17 páginas.

INSTALLING/CHANGING BLADES

1. Use only jigsaw blades with the

correct T-shank.

2. With the jigsaw disconnected

from the power supply, raise the

blade guard and press the blade

retainer to the right hand side.

3. Select the appropriate blade for

the job in hand, and insert it into

the blade holder as far as it will go

with the teeth facing forwards.

4. Release the blade retainer, ensuring that the blade remains as far into the

retainer as it will go, pressing against the resistance of the internal spring.

5. Pull the blade to check that it is secure before restoring the power supply.

• Take care never to use cracked, blunt or damaged blades.

IMPORTANT: DO NOT plug in to the mains, unless you have ensured the

jigsaw is switched OFF. To do this, squeeze the trigger fully upwards, then

release it. The trigger is located under the grip.

1. Ensure that the workpiece being cut is securely held in place and that the

cut line is clearly marked.

2. Connect the vacuum extractor port to an extract system where possible.

• The jigsaw is provided with a dust extract facility, where a vacuum

extractor may be connected to the rear of the machine. Please

note however, that this does not preclude the user from wearing a

face mask to prevent the inhalation of dust particles.

3. Place the sole-plate on the workpiece taking care that the blade is vertical

and correctly positioned in relation to the cut line without touching it. Push

the clear plastic blade guard down fully.

4. Ensure the blade is not striking anything below the workpiece and that the

power cable is well away from the moving blade before starting the saw.

• If cutting out an aperture it will be necessary to drill a suitably sized

hole in the workpiece for use as a starting point.

• Note that the blade should emerge from the workpiece at every

point of the cut.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]