Directed Security and Remote Start Manual de instalação - Página 14

Procurar online ou descarregar pdf Manual de instalação para Alarme para automóvel Directed Security and Remote Start. Directed Security and Remote Start 20 páginas. Security and remote start

Imprimir página

Menu 3 - Remote start

M e n u
One-chirp setting
Item
1
Engine checking: Virtual Tach
Remote start runtime: 12 mins
2
3
Parking light output: Flashing
Cranking time: 0.6 sec
4
5
Activation pulse 1
2nd Ignition/Acc output: Ignition
6
7
Acc state during wait-to-start Off
2nd status output: Normal
8
9
Anti grind: On
Diesel timer: Wait-to-Start input
10
11
Timer mode run time: 12 min
Timer mode: Timed starts
12
13
Short run (turbo): 1 min
*Additional settings using the Bitwriter®

Menu 3 - Descriptions

1. Engine Checking Mode
1.
Virtual Tach: battery voltage drop/rise during cranking determines when the starter output is released. During runtime, constant voltage
level is monitored to determine if the engine is running
2.
Voltage: starter output during cranking is a programmed duration (Set in Cranking Time). During runtime, constant voltage level is
monitored to determine if the engine is running
3.
Off: starter output during cranking is a programmed duration (Set in Cranking Time). The remote start will keep the ignition/accessories
active for the programmed runtime whether the engine is running or not
4.
Tachometer: tachometer input signal during cranking and runtime to determine when the starter output is released and if the engine is
running.
2. Run Time
•
12/24/60 minutes: sets engine runtime during normal remote start operations
3. Parking Light Output
1.
Flashing: the lights will pulse on/off during remote start
2.
Constant: the lights will turn on solid during remote start.
4. Cranking Time
•
0.6/0.8/1.0/1.2/1.4/1.6/1.8/2.0/4.0 seconds: determines the starter output duration during cranking for the 'Voltage' and the
'Off' Engine Checking Mode options
5. Activation Pulse Count
•
1/ 2 pulses: sets the number of remote control commands received or Activation Input required to activate and de-activate remote start
6. 2nd Ignition/Accessory Output:
•
This will allow the PINK/WHITE to be used as a 2nd ignition or an accessory. The default is 2nd ignition.
7. Accessory State During Wait-To-Start Off/On:
•
This feature will allow the selection of the accessory output to be ON or OFF during wait-to-start.
8. Status 2 Output (Dark Blue H2/10 wire)
1.
Status Normal: the output will activate before the ignition outputs turn on, and de-activate after they turn off during remote start
14
Two-chirp setting
Voltage(2), OFF(3), Tachometer(4)
24 min, 60 min*
Constant
0.8, 1.0, 1.2, 1.4, 1.6, 1.8, 2.0, 4.0 second
2
Accessory
On
Rear defogger: latch 10 min.
rear defogger pulse
Off
Timed 15 , 30 ,45 seconds*
3, 6, 9, min*
Temp starts
3,5, 10 min
© 2012 Directed. All rights reserved.