Zanussi ZFG06400WA Manual do utilizador - Página 10

Procurar online ou descarregar pdf Manual do utilizador para Congelador Zanussi ZFG06400WA. Zanussi ZFG06400WA 12 páginas.
Também para Zanussi ZFG06400WA: Manual do utilizador (12 páginas)

Imprimir página

Door reversibility

The side at which the door opens can be

changed from the left side

to the right side (as supplied), if the

installation site requires.

Warning!

When changing the side at which the door

opens, the appliance must not be connected

to the mains. Remove plug from the mains

beforehand.

1. Screw

2. Low Hinge

3. Upper Hinge

4. Adjustable Low Foot

5. Adjustable High Foot

6. Screw Bolt

7. Plug

8. Decoration Block

9. The block of the top cover

10. Top Cover Plate

11. Screw nail

1. Remove the screw nails (11).

2. Keep the door open, raise the end of the

top cover, push it(10) frontad and take

it off from the block(9) of the top cover,

then move the bottom block(8).

3. Remove the two screws blot (6) that

connect the upper hinge (5) on the right

side of the cabinet top.

4. Carefully lift the door and place it on a

padded surface to prevent scratching.

5. Remove the plug (7) and transfer it to the

uncovered hole on the right side of the

into the hole.

6. Remove the two screws(6) that hold the

lower hinge (2) on the right side of the

unit.

7. Remove the screw-type leveling front

leg (4) and transfer it to the right side as

8. Set the door into it's new place making

sure the pin enters the bushing at the

lower frame section (hole).

9. Secure the upper hinge (5) previously

removed in step 3 on the left side of the

unit. Make sure the pin enters the bushing

on the upper frame section (hole).

10. Loosely secure the lower left hinge (2)

and do not tighten the bolts until the door

is in the closed position and leveled.

11. Insert the plug (7) on the uncovered

holes (right side).

12. Fix the decoration block(8)in the right of

the top cover plate(10).

13. Keep the door open, raise the end of the

top cover, pull it(10) backwards to hitch

the block(9).

14. After the assembly of the top cover, close

screw(11).