Clarke PSP195 Manual de Instruções de Operação e Manutenção - Página 5
Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Bomba de água Clarke PSP195. Clarke PSP195 13 páginas. Puddle pump
Imprimir página
INSTALLING THE PUMP
WARNING: CHECK THE PUMP FOR DAMAGE BEFORE USE AND DO NOT
USE IF DAMAGED IN ANY WAY.
WARNING: THE WATER SEAL CONTAINS LUBRICANT WHICH IS NON-TOXIC
BUT WHICH MAY ALTER THE CHARACTERISTICS OF THE WATER IN THE CASE
OF PURE WATER, IF THE PUMP WERE TO DEVELOP ANY LEAKS.
1. Remove all packaging and make sure that the pump has no visible
damage. Dispose of all packaging appropriately.
• The stepped hose adaptor supplied is
designed to be used for either screw type
hose connection or push fit.
2. Connect a suitable hose (not supplied) to the
adaptor.
• Suitable hoses are available from your local
Clarke dealer.
3. When push fitting the hose to the adaptor use
a jubilee clip to secure it.
4. Stand the pump upright on a flat surface in the
water that you want to drain.
5. Ensure the pump is positioned with adequate
space - recommended minimum base area of
20 x 20 cm and the maximum depth of any
installation - 7 metres. The pump is supplied with 10 metres of power cable.
6. Always raise and lower the pump using the lifting handle and a rope
attached to it if required. Never lift or lower the pump using the power
cable.
• The filter base inlet must be fully submerged before the pump is switched
on and the pump is standing vertical.
7. Connect the mains plug to the mains supply via a high sensitivity residual
current device (RCD) which has a tripping current of less then 30mA.
8. Switch the mains power supply on.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
5