Clarke PSP195 운영 및 유지보수 지침 매뉴얼 - 페이지 5

{카테고리_이름} Clarke PSP195에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke PSP195 13 페이지. Puddle pump

INSTALLING THE PUMP

WARNING: CHECK THE PUMP FOR DAMAGE BEFORE USE AND DO NOT

USE IF DAMAGED IN ANY WAY.

WARNING: THE WATER SEAL CONTAINS LUBRICANT WHICH IS NON-TOXIC

BUT WHICH MAY ALTER THE CHARACTERISTICS OF THE WATER IN THE CASE

OF PURE WATER, IF THE PUMP WERE TO DEVELOP ANY LEAKS.

1. Remove all packaging and make sure that the pump has no visible

damage. Dispose of all packaging appropriately.

• The stepped hose adaptor supplied is

designed to be used for either screw type

hose connection or push fit.

2. Connect a suitable hose (not supplied) to the

adaptor.

• Suitable hoses are available from your local

Clarke dealer.

3. When push fitting the hose to the adaptor use

a jubilee clip to secure it.

4. Stand the pump upright on a flat surface in the

water that you want to drain.

5. Ensure the pump is positioned with adequate

space - recommended minimum base area of

20 x 20 cm and the maximum depth of any

installation - 7 metres. The pump is supplied with 10 metres of power cable.

6. Always raise and lower the pump using the lifting handle and a rope

attached to it if required. Never lift or lower the pump using the power

cable.

• The filter base inlet must be fully submerged before the pump is switched

on and the pump is standing vertical.

7. Connect the mains plug to the mains supply via a high sensitivity residual

current device (RCD) which has a tripping current of less then 30mA.

8. Switch the mains power supply on.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]