Clarke PSP195 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke PSP195에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke PSP195 13 페이지. Puddle pump

OPERATION

To operate the pump move the tab to the

required position for either Auto or Manual mode.

AUTOMATIC OPERATION (A)

To set the pump running automatically:

1. Move the tab until the indicator is positioned

on "A" (automatic).

• When the float reaches the ON level the

pump will start and will continue operating

until the float drops to the OFF level.

MANUAL OPERATION (M)

To manually start the pump:

1. Lift the tab until the indicator is positioned on

"M" (manual).

• The pump will run indefinately.

2. When the water level is down to 2-3 mm disconnect the pump from the

mains power suppy..

CAUTION: DO NOT ALLOW THE PUMP TO RUN DRY

The pump is fitted with a thermal overload switch. If the pump overheats for

any reason, it will automatically switch OFF. Once the pump has cooled (at

least 5-10 minutes), it will automatically restart.

AFTER USE

If the temperature is lower than 0°C, ensure there is no residual water in the

pump which could freeze, causing cracks in the plastic parts.

If the pump has been used with substances that tend to form a deposit, or

with water containing chlorine, rinse it after use with a powerful jet of water in

order to avoid the formation of deposits which would reduce the

performance of the pump.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]