Clarke 3120181 Instruções de funcionamento e manutenção - Página 7

Procurar online ou descarregar pdf Instruções de funcionamento e manutenção para Serra Clarke 3120181. Clarke 3120181 17 páginas. Sabre saw

• Never exceed the maximum operating pressure for the air tool. It is

recommended that air pressure to this tool does not exceed 90 psi

(6.2 bar) at the tool when running. Higher pressures and unclean air

will shorten the life of the tool due to faster wear and is a possible

safety hazard.

BEFORE USE

WARNING: MAKE SURE THAT THE SAW IS DISCONNECTED FROM THE AIR

SUPPLY BEFORE INSTALLING, REMOVING OR REPLACING THE BLADE.

FITTING/REPLACING THE BLADE

1. Loosen the set screw (A) on the

blade holder (B) with the hex key

counterclockwise.

2. Identify the material and then

select the correct blade for your

operation.

3. Always use the correct saw blade

for the material for smooth and

fast cutting.

• It is recommended that operators use 32T blades for cutting light

sheet metal, body panels, exhaust pipes, etc., use 24T blades for

general purpose sawing including aluminum and other soft

materials, and use 18T blades for cutting plastic, reinforced

fiberglass, wood, etc.

4. Insert a saw blade (D) into the blade holder as far as it will go.

5. Tighten the set screw (A) with the

hex key by turning clockwise.

Ensure the saw blade is held tightly

to avoid it coming loose.

6. Loosen the setscrew (E) and adjust

the position of the work guide (F)

according to the depth of cut

required.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]