3DHobbyShop.com Vyper 46" ARF Manual de montagem - Página 6

Procurar online ou descarregar pdf Manual de montagem para Brinquedo 3DHobbyShop.com Vyper 46" ARF. 3DHobbyShop.com Vyper 46" ARF 19 páginas.

Slide the right side elevator onto the stabilizer, inserting the fiberglass joiner strip through the fuselage

cutout as shown – DO NOT GLUE THE HINGES YET.

Slide the left elevator onto the stabilizer, gluing the fiberglass joiner strip in with medium or thick CA – DO

NOT GLUE THE HINGES YET.

Once the joiner strip glue is dry, flex the elevators up and down to make sure you can achieve 45 degree

of elevator throw in each direction without binding. If the elevator hinge gap is too tight, the elevators will

bind, so flexing them up and down before gluing ensures that you will have no binding. Apply two drops

Slide the rudder onto the back of the vertical stab, make sure the rudder swings freely 45 degrees as you

did on the elevators and glue the hinges with thin CA glue. Allow to dry.

of thin CA to each hinge and allow to dry.