3DHobbyShop.com Vyper 46" ARF 조립 설명서 - 페이지 6
{카테고리_이름} 3DHobbyShop.com Vyper 46" ARF에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DHobbyShop.com Vyper 46" ARF 19 페이지.
페이지 인쇄
Slide the right side elevator onto the stabilizer, inserting the fiberglass joiner strip through the fuselage
cutout as shown – DO NOT GLUE THE HINGES YET.
Slide the left elevator onto the stabilizer, gluing the fiberglass joiner strip in with medium or thick CA – DO
NOT GLUE THE HINGES YET.
Once the joiner strip glue is dry, flex the elevators up and down to make sure you can achieve 45 degree
of elevator throw in each direction without binding. If the elevator hinge gap is too tight, the elevators will
bind, so flexing them up and down before gluing ensures that you will have no binding. Apply two drops
Slide the rudder onto the back of the vertical stab, make sure the rudder swings freely 45 degrees as you
did on the elevators and glue the hinges with thin CA glue. Allow to dry.
of thin CA to each hinge and allow to dry.
6