3DUpFitters Artillery Sidewinder X1 Enclosure Kit Manual de instalação - Página 11

Procurar online ou descarregar pdf Manual de instalação para Impressoras 3D 3DUpFitters Artillery Sidewinder X1 Enclosure Kit. 3DUpFitters Artillery Sidewinder X1 Enclosure Kit 13 páginas.

Imprimir página

attached to the adapter as shown in the picture to the right. The screws are 14mm M5.

The cable for the runout sensor can be

inserted through the top slit and attached as

show to the right.

8. Air Input Tray

In order to get enough air to the electronics

without also cooling down the inside there are

two air input vents, one on each side of the

case. The air is brought into the case through

the side vents, and then it exits through the

front tray, pictured at right. It consists of two

parts, the tray, and a cover insert.

Slide the front tray into the front of the enclosure, and then lay the cover on top at the

front as shown above. Note that you'll need to lift the printer as you do so so that the

tray can ﬁt over the metal fan screen on the bottom of the printer. Adjust the location

of the enclosure so that the tray completely covers the case's air intake vent.

There are holes to use 12mm M4 screws to attach the tray, but it's not needed in many

cases. If you do attach it, it must be unscrewed before you can take oﬀ the

enclosure.

9. Sealing Gaps

Once the enclosure is completely put together, it is time to make sure that each of the

panels is held tightly to each adjoining panel. The connectors are designed with a

small amount of play that allows you to make small adjustments for the perfect ﬁt.