3DUpFitters Artillery Sidewinder X1 Enclosure Kit Посібник з монтажу - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник з монтажу для 3D-принтери 3DUpFitters Artillery Sidewinder X1 Enclosure Kit. 3DUpFitters Artillery Sidewinder X1 Enclosure Kit 13 сторінок.
attached to the adapter as shown in the picture to the right. The screws are 14mm M5.
The cable for the runout sensor can be
inserted through the top slit and attached as
show to the right.
8. Air Input Tray
In order to get enough air to the electronics
without also cooling down the inside there are
two air input vents, one on each side of the
case. The air is brought into the case through
the side vents, and then it exits through the
front tray, pictured at right. It consists of two
parts, the tray, and a cover insert.
Slide the front tray into the front of the enclosure, and then lay the cover on top at the
front as shown above. Note that you'll need to lift the printer as you do so so that the
tray can fit over the metal fan screen on the bottom of the printer. Adjust the location
of the enclosure so that the tray completely covers the case's air intake vent.
There are holes to use 12mm M4 screws to attach the tray, but it's not needed in many
cases. If you do attach it, it must be unscrewed before you can take off the
enclosure.
9. Sealing Gaps
Once the enclosure is completely put together, it is time to make sure that each of the
panels is held tightly to each adjoining panel. The connectors are designed with a
small amount of play that allows you to make small adjustments for the perfect fit.
Copyright 2020 3DUPfitters LLC
11