Division 6 Dual Mini Instruções de construção - Página 3

Procurar online ou descarregar pdf Instruções de construção para Sintetizador Division 6 Dual Mini. Division 6 Dual Mini 4 páginas.

Install Buttons

Insert tact switches S1-S4 into the PCB. They fit 2 different ways, and either

way is fine. They will snap into place, making it easy to flip the board over and

solder them. Make sure they are flat and straight as you insert them. You may

want to temporarily place the the front panel to make sure the buttons line up

with the holes in the panel. Once everything is lined up, solder the button

pins. The pins are short enough that they don't need to be trimmed.

Install 3.5mm Jacks

Insert J1-J26 into the main PCB, soldering one pin of each as you go to hold it

in place. Check to make sure that they are flat against the board and lined up

with the silkscreen pattern; reheat and reposition if not. Place the front panel

on the jacks to ensure alignment, and solder the remaining pins.

Install Pots

Be careful here, because there's one pot per synthesizer that's different from

the rest! R7 and R20 are 1M (say B105 on the bottom), where all the others are

10k (say B103 on the bottom).

Dual Mini Synthesizer Build Instructions

Insert all the pots, making sure they are as straight and flat to the PCB as

possible. Solder one mounting tab on each pot. Temporarily install the front

panel to ensure all the pot shafts are poking through the center of their holes.

If any pot needs adjustment, simply heat up the one tab you soldered and

adjust the positioning of the pot.

Once all the shafts are lined up to your satisfaction, solder the remaining pins

on the pots.

Attach Standoffs

Using 2 silver screws, attach the 2 standoffs so that they protrude from the

same side of the board you just installed the pots on. The holes for the

standoffs aren't labeled, but they have thick silver rings around them.

Continued...

Page 3/4