Division 6 Dual Mini Instruções de construção - Página 4

Procurar online ou descarregar pdf Instruções de construção para Sintetizador Division 6 Dual Mini. Division 6 Dual Mini 4 páginas.

Install Front Panel

Place the front panel on the module. Install the hex nuts on all the jacks.

Screw the two black screws into the standoffs to hold the top of the panel in

place.

Install Microcontrollers

Before inserting U1 and U2 into their sockets, you may need to bend the pins

inward a bit so that they'll line up with the holes. Lay each IC on its side on a

flat surface, then gently press down on the top of the chip so that the pins

bend evenly. Repeat for the other side of each chip.

Insert the chips into their sockets, making sure that the pin 1 notches on each

chip and socket are aligned with each other. Both ICs are identical, so it

doesn't matter which chip goes into which socket.

Dual Mini Synthesizer Build Instructions

Power Up

That's it, you're finished! It's time to test out your handiwork. Connect the

module to a Eurorack power supply using the provided cable. Turn on the

power.

Both the synthesizers should blink their firmware revisions on the LEDs, then

the LFO LEDs should start blinking at LFO rate.

Connect the OUT jack to an amplifier/speaker. Make sure the FILTER pot is all

the way up and LFO>VCO and LFO>VCA are set to the 12:00 positions. Press

the GATE button; you should hear some audio.

Now you can use the controls to dial in the sound you want.

Troubleshooting:

· If the module has no power at all, check to make sure the diode is

installed the right direction. Also use a voltmeter to verify that your

Eurorack power supply is working.

· If any LED seems to be stuck on, it may be installed backwards.

· For any other problems, start by checking all your solder joints. They

should look shiny and smooth, not dull. Look for blobs and shorts

between adjoining pads.

Page 4/4

Calibration instructions can be found at

division-6.com/dualsynth

Still have problems? Email us at [email protected]!

THE END