ESI 2TD-C48-30-SLV Manual de instruções de montagem - Página 6

Procurar online ou descarregar pdf Manual de instruções de montagem para Mobiliário de interior ESI 2TD-C48-30-SLV. ESI 2TD-C48-30-SLV 12 páginas.

Trada 2-leg

Step #5: position assembled frame on underside of worksurface

With the table top facing down on a soft, clean surface, turn the assembled frame upside-down

and center it on the underside of the worksurface.

• Use a 3mm Allen key to loosen the set screw on each crossbar near the end where the exposed channel begins.

• Expand the crossbars as necessary to position the side brackets 1.0" from the left and right edges

of the worksurface.

— Be careful not to dislodge any of the rubber bumpers when expanding the crossbars.

• Tighten the set screws to securely hold the side-to-side width of the crossbars.

Step #6: hook power supply holder under rear crossbar

• Raise the rear crossbar just enough to hook the holder for the power suppy in the desired position.

— Position the holder so that the power supply will be located between the two crossbars.

— Position the holder so it does not cover any of the through-holes used to attach the crossbars to the worksurface.

— Be sure the holder does not cover any of the rubber bumpers.

3mm Allen key

loosen

1.0"

Page 6

tighten

expand crossbars

as necessary

set screws

holder

Assembly

1.0"