ESI 2TD-C48-30-SLV Інструкція з монтажу Посібник з монтажу - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Внутрішнє оздоблення приміщень ESI 2TD-C48-30-SLV. ESI 2TD-C48-30-SLV 12 сторінок.
Друкувати сторінку
Trada 2-leg
Step #5: position assembled frame on underside of worksurface
With the table top facing down on a soft, clean surface, turn the assembled frame upside-down
and center it on the underside of the worksurface.
• Use a 3mm Allen key to loosen the set screw on each crossbar near the end where the exposed channel begins.
• Expand the crossbars as necessary to position the side brackets 1.0" from the left and right edges
of the worksurface.
— Be careful not to dislodge any of the rubber bumpers when expanding the crossbars.
• Tighten the set screws to securely hold the side-to-side width of the crossbars.
Step #6: hook power supply holder under rear crossbar
• Raise the rear crossbar just enough to hook the holder for the power suppy in the desired position.
— Position the holder so that the power supply will be located between the two crossbars.
— Position the holder so it does not cover any of the through-holes used to attach the crossbars to the worksurface.
— Be sure the holder does not cover any of the rubber bumpers.
3mm Allen key
loosen
1.0"
Page 6
tighten
expand crossbars
as necessary
set screws
power supply
holder
Assembly
1.0"