Edgewater Networks EdgeMarc 4550 Manual de instalação do hardware - Página 7
Procurar online ou descarregar pdf Manual de instalação do hardware para Porta de entrada Edgewater Networks EdgeMarc 4550. Edgewater Networks EdgeMarc 4550 18 páginas. Networking gateway
Também para Edgewater Networks EdgeMarc 4550: Manual de início rápido (6 páginas)
Imprimir página
EdgeMarc 4550 Networking Gateway Installation Guide
Back Panel
A
Power Connector
10/100 Mbps
B
Ethernet LAN
Ports
10/100 Mbps
C
Ethernet WAN
Port
Management
D
Console Port
E
USB Ports
F
Erase Button
Figure 2: 4550 Back Panel
Name
Accepts the plug from the supplied power cord to connect the unit
to an AC power outlet.
Local Area Network (LAN) ports to connect the IP phones or an
Ethernet switch. Unit can also be configure through any of these
ports using the web interface
This port is typically used when connecting the 4550 to an existing
WAN router, cable or xDSL modem.
This port is used to establish a local console session with the 4550
using a VT100 terminal or emulation program. The cable required
is a straight-through DB-9 cable. The serial port uses a baud rate
of 9600, 8 data bits, 1 stop bit and no parity.
This port is used for debug or local diagnostic purposes only.
Primary configuration of the 4550 is performed from a web
browser as covered in VOS User Manual
2 x USB ports
If pressed twice in quick succession, only the CLI password will be
changed back to its original password.
If pressed three times in quick succession, the EdgeMarc will
revert back to the factory default settings. This will reset all
passwords and erase all prior configurations. The default LAN
address will be set to 192.168.1.1.
Caution
Using the Erase button as outlined above means any
configuration made to the 4550 will be lost. Erasing the
configuration means that IP phones installed behind the 4550
will not work and Internet connectivity or network access for
Description
4