Edgewater Networks EdgeMarc 4550 Manual de instalação do hardware - Página 9
Procurar online ou descarregar pdf Manual de instalação do hardware para Porta de entrada Edgewater Networks EdgeMarc 4550. Edgewater Networks EdgeMarc 4550 18 páginas. Networking gateway
Também para Edgewater Networks EdgeMarc 4550: Manual de início rápido (6 páginas)
Imprimir página
Getting Started
Physical Installation
The 4550 is designed for desktop, rack or wall-mount installation. Observe the following
guidelines when installing the system:
•
Always verify that the AC cord is disconnected from a power source prior to installation.
Ensure that the installation site has adequate air circulation and meets the minimum
•
operating conditions for the system as specified in Specifications section of this document
Required Tools and Materials
If the unit is to be mounted on the wall then:
•
1 Flat or Philips screw driver
2 round or flat head Philips or slotted screws – 1
2 hollow wall anchors
•
If the unit will be mounted in a shelf:
1 Flat or Philips screw driver
•
If T1/E1 port will be used to connect to WAN
T1 cable to connect the T1/E1 port to a T1 line.
Warning
To reduce the risk of fire, use only 26 AWG or larger wire (e.g. 24, 22, 20, etc.) to
connect the T1 port on your unit to an RJ-45 jack.
•
Ethernet cables to connect the LAN ports to LAN switches or to individual IP phones. They
can also be used to connect the Ethernet WAN port to a WAN router, a Cable Modem or a
DSL Modem, if T1/E1 port is not being used to connect to the WAN.
inch long
2
6