3LeggedThing PUNKS Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Acessórios para câmaras 3LeggedThing PUNKS. 3LeggedThing PUNKS 9 páginas.
Também para 3LeggedThing PUNKS: Manual (9 páginas)

Imprimir página

To open and extend the tripod legs simply grip the leg locks (b) in your

hand quarter turn, loosening the legs allowing you to select a desired

height. Once the required height has been obtained, lock the legs in

place by rotating back to the original position, which will fully engage

the leg lock. The friction locks do not require to be undone further

than a half turn, unless you intend to completely disassemble the legs

for cleaning.

Cleaning

It is advised that you wash your tripod after using it in saltwater,

sand, dirt, or mud and this can be done by undoing each leg.

Take each individual leg lock and unscrew until completely

undone, and and gently pull the tubing (a) out, allowing you to

clean the threads of the legs. Be careful not to lose the Chicken

Lips (shims) (b ). Once cleaned, dry all the parts with a clean cloth.

Do not leave them to air dry. Then ensure that the Chicken Lips

(shims) are in place lining up with the hole (c) and then carefully

insert the leg, lining up the internal key lines with the gaps in the

Chicken Lips and tighten the leg lock in place.

Never use WD40 on your tripod as it can be a solvent.

Always use silicone grease.

Legs, catches & locks

In order to change the leg angle or to stow away your tripod you will

need to pull down on the leg catch (a) maneuver the leg into the desired

position and then release the catch.