3LeggedThing PUNKS Інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Аксесуари для фотоапаратів 3LeggedThing PUNKS. 3LeggedThing PUNKS 9 сторінок.
Також для 3LeggedThing PUNKS: Посібник (9 сторінок)
Друкувати сторінку
To open and extend the tripod legs simply grip the leg locks (b) in your
hand quarter turn, loosening the legs allowing you to select a desired
height. Once the required height has been obtained, lock the legs in
place by rotating back to the original position, which will fully engage
the leg lock. The friction locks do not require to be undone further
than a half turn, unless you intend to completely disassemble the legs
for cleaning.
Cleaning
It is advised that you wash your tripod after using it in saltwater,
sand, dirt, or mud and this can be done by undoing each leg.
Take each individual leg lock and unscrew until completely
undone, and and gently pull the tubing (a) out, allowing you to
clean the threads of the legs. Be careful not to lose the Chicken
Lips (shims) (b ). Once cleaned, dry all the parts with a clean cloth.
Do not leave them to air dry. Then ensure that the Chicken Lips
(shims) are in place lining up with the hole (c) and then carefully
insert the leg, lining up the internal key lines with the gaps in the
Chicken Lips and tighten the leg lock in place.
Never use WD40 on your tripod as it can be a solvent.
Always use silicone grease.
Legs, catches & locks
In order to change the leg angle or to stow away your tripod you will
need to pull down on the leg catch (a) maneuver the leg into the desired
position and then release the catch.
a
b
b
a
c