Customidea GeoPic II Manual de instruções - Página 4

Procurar online ou descarregar pdf Manual de instruções para Acessórios para câmaras Customidea GeoPic II. Customidea GeoPic II 20 páginas. Geotagging device for nikon d200/d2hs/d2x/d2xs fuji s5 pro

Imprimir página

Quick start guide

The GeoPic II is powered up or down by pressing and

holding the function button and it starts up in the mode

you last used.

The three modes of operation are called continuous, low

power and freeze mode, and can be changed by half

pressing the shutter release button then pressing the

function button:

Each mode has its own colour and operates as follows:

Mode:

Continuous GPS location is continuously sent to the camera if locked to

Low Power

Freeze

Nikon D200, D2HS, D2X and D2XS and Fuji S5 Pro are registered

trademarks or a trademark of their respective companies.

Description

the satellites. The status light will slowly flash red when

there is no lock and be continuously red if there is.

GPS location is sent to the camera if locked to the satellites

AND shutter release button is half pressed. When unlocked

the status light will slowly flash green. When locked the

status light will only occasionally blink green to let you know

it is ready. GPS location will be sent to the camera the

moment the shutter release button is half pressed. Wait

until the beep and the green light is lit to take the picture.

GPS location is frozen on demand in an internal buffer.

Press the function button to start a new search and freeze a

new location. Cancel a search by pressing the function

button again. When searching for a new location, the status

light will slowly flash blue. When a location is frozen the

status light will occasionally blink blue to let you know it is

ready. GPS data will be sent to the camera the moment the

shutter release button is half pressed, in the same manner

as the low power mode. Wait until the beep sounds, and

the blue light is lit to take the picture