ALUZ A8-ZIZA-SOP Manual de instruções de instalação - Página 10

Procurar online ou descarregar pdf Manual de instruções de instalação para Equipamento de iluminação ALUZ A8-ZIZA-SOP. ALUZ A8-ZIZA-SOP 12 páginas.

ZIZA
Standard Optic
A8-ZIZA-SOP
1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment of
mounting channels.
2
Lay extrusions along chalk line and drill at least 3 countersink holes per
extrusion. Drill additional holes as needed.
3
Screw extrusions to surface using countersink screws.
Note: Ensure extrusions are aligned. Misalignment will prevent lens from
snapping in.
Extrusions aligned
4
After all extrusions have been securely mounted, remove adhesive backing
from lightstrip and adhere in place along extrusion channel, ensuring
lightstrip is secure inside extrusion.
Note: Refer to Application Guidelines to ensure correct installation.
Countersink hole
Countersink screw
Install lightstrip into extrusions
Remove adhesive backing
ALUZ
1170 North Red Gum Street, Anaheim, CA 92806
Phone: 800 921 2254 or 714 535 7900 | Fax: 714 535 7902 | [email protected] | aluz.lighting
© ALUZ All rights reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
Mounting Fixture (Wet Location Unassembled Mounting Channel)
5
If applicable, connect disconnects between luminaires or solder connectors
using the steps from Application Guidelines.
6
Install lens into extrusion, overlapping where two extrusions meet. Plan
your cuts so that the lens will always overlap where two extrusions meet.
Overlapping lenses helps keep extrusions aligned and prevents light leaks.
Two extrusions meet
7
Perform a continuity test before connecting luminaire to power source.
Installation Instructions
9 / 1 / 2021 / Rev 0
Page 10 of 12
Lens overlapping