ALUZ A8-ZIZA-SOP Manual de instruções de instalação - Página 8

Procurar online ou descarregar pdf Manual de instruções de instalação para Equipamento de iluminação ALUZ A8-ZIZA-SOP. ALUZ A8-ZIZA-SOP 12 páginas.

ZIZA

Standard Optic

A8-ZIZA-SOP

Measure area where luminaire will be installed. Use a laser line to create

a reference line along installation area, ensuring consistent alignment of

mounting clips. Mark location where each mounting clip will be installed

along reference line.

Mark location where mounting clips will be installed.

Note: The number of required mounting clips differs for dry and wet location

products. Verify number of mounting clips is appropriate for installation

environment before installing. Do not install luminaires with inadequate

number of mounting clips.

Lay mounting clips along reference line and pre-drill using an appropriate

drill bit for surface and screw size. Recommendation: 8/32 x 1" screw.

Note: Allow 0.25" clearance for lateral expansion of assembled mounting clips.

Only install mounting clips on flat, even surfaces.

Screw mounting clips to surface, then snap extrusions into mounting clips.

Note: Ensure extrusions are aligned. Misalignment will prevent lens from

snapping in.

After all extrusions have been securely mounted, remove adhesive backing

from lightstrip and adhere in place along extrusion channel, ensuring

lightstrip is secure inside extrusion.

Note: Refer to Application Guidelines to ensure correct installation.

Install lightstrip into extrusions

Remove adhesive backing

ALUZ

1170 North Red Gum Street, Anaheim, CA 92806

Phone: 800 921 2254 or 714 535 7900 | Fax: 714 535 7902 | [email protected] | aluz.lighting

Mounting Fixture (Dry Location Mounting Clips)

If applicable, connect disconnects between luminaires or solder connectors

using the steps from Application Guidelines.

Install lens into extrusion, overlapping where two extrusions meet. Plan

your cuts so that the lens will always overlap where two extrusions meet.

Overlapping lenses helps keep extrusions aligned and prevents light leaks.

Perform a continuity test before connecting luminaire to power source.

Installation Instructions

9 / 1 / 2021 / Rev 0

Page 8 of 12

Two extrusions meet

Lens overlapping