ALUZ A8-ZIZA-TAPE Manual de instruções de instalação - Página 9
Procurar online ou descarregar pdf Manual de instruções de instalação para Equipamento de iluminação ALUZ A8-ZIZA-TAPE. ALUZ A8-ZIZA-TAPE 11 páginas. Led tape
Também para ALUZ A8-ZIZA-TAPE: Manual (14 páginas)
Imprimir páginaZIZA
Tape
A8-ZIZA-TAPE
1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment
of mounting channels. Mark location where mounting channels will be
installed along reference line.
2
Mark location where mounting clips will be installed.
Note: The number of required mounting clips differs for dry and wet location
products. Verify number of mounting clips is appropriate for installation
environment before installing. Do not install luminaires with inadequate
number of mounting clips.
3
Prepare for mounting by removing adhesive backing from mounting clips.
Remove adhesive backing
4
Adhere mounting clips to surface, then snap luminaire into mounting clips.
Adhesive surface
Install square tube
into mounting clips
ALUZ
1170 North Red Gum Street, Anaheim, CA 92806
Phone: 800 921 2254 or 714 535 7900 | Fax: 714 535 7902 | [email protected] | aluz.lighting
© ALUZ All rights reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
Mounting Lightstrip (Wet Location Mounting Clips)
5
Ensure tube is secured in place.
6
If applicable, position jumper wires between luminaire segments as needed.
Note: Refer to Design Guidelines - Continuous Run (Wet Location) for details.
7
If applicable, connect disconnects between luminaires or solder connectors
using the steps from Application Guidelines.
8
Perform a continuity test before connecting luminaire to power source.
Installation Instructions
9 / 1 / 2021 / Rev 0
Page 9 of 11
Ensure tube is
secured in place