ALUZ ZIBI A1 Series Manual - Página 5
Procurar online ou descarregar pdf Manual para Equipamento de iluminação ALUZ ZIBI A1 Series. ALUZ ZIBI A1 Series 13 páginas. Surface zuco pivot bios illuminated
Também para ALUZ ZIBI A1 Series: Manual de instruções de instalação (12 páginas), Manual (11 páginas), Manual (11 páginas), Manual de instruções de instalação (11 páginas)
Imprimir página1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment of
mounting clips. Mark location where each mounting clip will be installed
along reference line.
2
Use 1 mounting clip every 2', rounded up. Use a minimum of 2 mounting clips
per luminaire segment. For vertical applications, create a stopper at the
bottom of the run to prevent sliding.
3
Space mounting clips evenly throughout the run.
Example: 20' Run.
8'
3" Gap
Mounting Clip
4
Insert stakes into ground until entire tapered portion is submerged.
Note: The ground must be able to support the weight of luminaires.
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Standard Dynamic White
(A1-ZIBI-STN-DWH)
20'
8'
4'
Junction between luminaire segments
866.ALUZ.LTG | 714.535.7900
5
Ensure each stake is secured in place, then snap luminaires into
mounting clips.
6
If applicable, connect disconnects between luminaires. Slide
shrink tube over connectors and apply heat. The shrink tube will
shrink down, sealing the connectors. Apply silicone around sealed
connectors for a stronger seal.
Page 5 of 13
Stake Mounting Clip
Installation Instructions
9 / 11 / 2023 / Rev 4