Alvarado CSG Manual de instruções de instalação e manutenção - Página 5

Procurar online ou descarregar pdf Manual de instruções de instalação e manutenção para Vedações & Portões Alvarado CSG. Alvarado CSG 10 páginas. Bi-directional waist high security gate

Imprimir página

CSG/SSG/CFG Installation and Maintenance Instructions

Installation Instructions

Anchoring the Hinge Post

1. Once the installation location has been determined,

snap a chalk line on the floor to mark the gate

centerline [Figure 4].

2. Mark the hinge post center and end-of-gate locations

(approximately 41.5") along the centerline. Snap a

chalk line to mark the hinge post centerline

[Figure 4].

3. Center the hinge post where the centerlines meet.

Starting with the flange hole directly under the gate

arm, mark every other hole for a total of (4) anchor

holes [Figure 5]. Set hinge post aside.

NOTE

In some situations, you may not be able to use every

other flange hole (e.g. hitting rebar). In this case use

adjacent flange holes as necessary.

4. Using a hammer drill fitted with a 5/8" concrete drill

bit, drill each anchor hole to a depth of 3".

NOTE

For terrazzo, ceramic tile, or brick veneer

installations, add the thickness of the finished floor

material to the anchor hole depth. Longer anchor

bolts and spacers may be required.

5. Using a shop vac, remove all debris from the anchor

holes before installing the anchors. If the holes

are not clear of debris, the anchors may not seat

properly.

6. Insert anchors into the drilled holes with the threaded

ends down. If needed, use a rubber mallet to tap the

anchor into place. Ensure that the anchors are flush

with the concrete floor [Figure 6].

7. Reposition the hinge post and align the flange holes

with the anchors.

8. Insert a 3/8" anchor bolt and washer though the

flange into each of the anchors.

9. Using a socket wrench and 9/16" socket, tighten

the (4) 3/8" bolts.

10. Use a torque wrench to torque the bolts to 20 ft-lbs.

11. Using a level, verify that the hinge post is straight

and level. If necessary, use washer shims and re-

level.

NOTE

It is important that the hinge post is horizontally and

vertically level with the floor. If not, the gate arm may

not self-close and center properly.

12. Locate the base cover. Using a #2 Phillips head

screwdriver, remove the (2) screws fastening the (2)

halves together.

13. Position the (2) halves of the base cover around the

hinge post flange and secure with the (2) screws

[Figure 7].

Created on: 10/7/2013

For Assistance: [email protected] (909) 591-8431

Fig. 4

Marking Centerlines

GATE

CENTERLINE

41.5"*

41.5"

FIGURE 7.1.2

Locating the hinge post centerline.

Fig. 5

Marking Anchor Holes

Flange

Fig. 6

Inserting Anchors

Post with Anchor

Hole Alignment

Threaded Side

Down

Flush with

Concrete

Fig. 7

Base Cover

Page 5

PUD3570R2-0