DNP DS40 Manual de manutenção - Página 2
Procurar online ou descarregar pdf Manual de manutenção para Impressora DNP DS40. DNP DS40 6 páginas. Photo imaging
Também para DNP DS40: Referência rápida (6 páginas), Manual de início rápido (8 páginas), Manual de reembalagem (2 páginas)
Imprimir página
Procedure – Changing Media
Paper
1.
To access the paper roll, open printer by lifting the
blue handle under scrap box and pulling gently
forward (Figure 2).
2.
Push blue paper release lever, located on the left-
hand side of the printer (Figure 3). The top panel of
the printer face will pop up allowing you to access
the paper area.
3.
Remove scrap box by pulling it straight up from the
printer base & set aside. Discard any offcuts at this
time.
4.
Remove the paper cassette, including spool ends &
any remaining paper by lifting it directly up from the
printer base.
NOT DISCARD THE SPOOL ENDS.
5.
Install the new roll of paper onto the spool ends
ensuring that there is no gap between the holder &
the edge of the paper roll.
6.
Place the paper into the printer with the paper
feeding over the top and under into the printer
(Figure 4).
7.
Gently feed the paper into the printer as shown in
the photo below. When this has been done correctly
you will hear a 'beep'.
8.
Reattach the scrap box by positioning it straight down from the top into the front of
the printer. Close the front cover.
Discard any remaining paper.
Figure 2 – O pening the front of the printer
DO
Figure 3 – Loc ation of paper release lever
Figure 4 – Direction for feeding paper into
printer