Akoma Pet Products Heat-N-Breeze Manual - Página 3
Procurar online ou descarregar pdf Manual para Aquecedor Akoma Pet Products Heat-N-Breeze. Akoma Pet Products Heat-N-Breeze 5 páginas.
Imprimir página
HEAT-N-BREEZE INSTALLATION INSTRUCTIONS
1
MARK SPOT FOR
5" HOLE
Decide where the
Heat-N-Breeze will be
mounted. Typically it should
be mounted higher so the
air outlet blows on the
animal. The 5" hole should
be drilled 6 1/8" over and
3" down from the upper left
corner of the housing unit.
5
FEED CORD AND FLEXIBLE DUCT
THROUGH THE 3/4" FOAM
AND THE 5" HOLE TO OUTSIDE
8
MOUNT OUTSIDE COVER TO OUTSIDE
WALL WITH SHORTER SCREWS
If there are gaps around outside cover unit and
the wall, fill with a caulk type sealer.
Half way between MEDIUM and HIGH is approximately 70 degrees F. Setting it closer to MEDiUM will mean unit will come on at a cooler temperature.
Since the HEAT-N-BREEZE uses so little energy, many customers will leave it run continuously during the warm summer months.
WARRANTY - If you should experience any problems with your HEAT-N-BREEZE, please contact the Hound Heater Company directly.
Please go to:
Included: 5" hole saw, 6 short screws, 3 long screws, 3/4" foam seal
2
ASSEMBLE
5 "
HOLE
S AW
Insert
c huck
e nd
o f
d rill
thru
h ole
a nd
t hread
n ut
on
t he
o ther
s ide.
3
DRILL
5 "
H OLE
ATTACH HEAT-N-BREEZE UNIT TO
INSIDE WALL WITH THE LONGER
9
APPROXIMATE TEMPERATURE SETTINGS
www.houndheater.com
and use the email contact on the site or use
TOOLS REQUIRED:
Not included: Drill, screwdriver & measuring device
ATTACH FLEXIBLE DUCT TO HEAT-N-BREEZE
You may not need to use the flexible tubing, however,
to create a tight seal between the unit and the vent,
6
SCREWS
MOUNT THE
HEAT SHIELD
1" ABOVE
THE
HEAT-N-BREEZE
4
UNIT WITH HOSE CLAMP
FOR THIN WALLED HOUSES 1.5" OR LESS
please use the 3/4" foam piece.
7
ATTACH OUTSIDE
FLEXIBLE DUCT
WITH HOSE CLAMP
10
SET THERMOSTAT TO
DESIRED SETTING
PLUG CORD INTO GFI OUTLET
AND YOU ARE DONE!
COVER TO