Fleetworks FLTW-7632 Instruções de instalação - Página 2
Procurar online ou descarregar pdf Instruções de instalação para Acessórios para automóveis Fleetworks FLTW-7632. Fleetworks FLTW-7632 4 páginas. Grand cherokee, dodge durango, dodge caravan factory display radio camera
Imprimir páginaStep 1: Determine Camera location. Place
template in desired position to confirm fitment.
(IMPORTANT: Some states prohibit items blocking
the license plate; check local authorities to confirm
legal status for your application).
Step 2: Mark Camera location with supplied
template, Center Punch the mark, and use
supplied 19mm Hole Saw to drill Camera
mounting hole. NOTE: If your vehicle has a
liftgate panel/ trunk trim cover, it must be
removed.
Step 3: (If necessary) Use a ¼" Drill Bit to
make a pass through hole in any obstructing
panel for the Camera Harness connector.
Step 4: Insert connector end of the Camera
Harness through the hole(s) you drilled.
RECOMMENDED: Protect Camera Harness from any
sharp metal edges by applying a small amount of
silicone caulk or a rubber grommet (shown below)
to any area that may come into contact with metal.
Step 5: Route Camera and/ or Chassis
Harness along existing wiring and secure
using Wire Ties or Electrical Tape.
FLTW-7632 Instructions 9-1-15.doc
INSTALLATION
I NSTRUCTIONS
Step 6: Connect Camera Harness to supplied
Chassis Harness. The optimal location for this
junction may occur at the top of the liftgate or
inner trunk edge.
Step 7: Route Chassis Harness forward. It
may be necessary to remove sill plates, pillar
covers, side panels, etc. Use a Plastic Trim Removal
Tool to avoid damage to trim pieces.
Step 8: Use a Plastic Trim Removal Tool,
7mm Socket, and/or Phillips Screwdriver to
remove garnish and fasteners securing the
radio display.
Step 9: Unplug all radio connectors from the radio
head unit and set radio aside.
Only complete Step 10 for 2014 Dodge
Durango and 2014 Jeep Grand Cherokee
vehicles.
Step 10: Insert terminal from red wire on
supplied chassis harness into position 31 of
black 52-pin radio connector and insert
terminal from black wire on supplied chassis
harness into position 32 of black 52-pin radio
connector.
Page 2 of 4