Fleetworks FLTW-7632 Instruções de instalação - Página 3
Procurar online ou descarregar pdf Instruções de instalação para Acessórios para automóveis Fleetworks FLTW-7632. Fleetworks FLTW-7632 4 páginas. Grand cherokee, dodge durango, dodge caravan factory display radio camera
Imprimir páginaNOTE: If vehicle is NOT equipped with a 22-
pin radio connector (Figure 1), use supplied
White connector to complete Steps 23 & 24.
Figure 1
IMPORTANT: If the White 22-pin connector is
present in the vehicle and Pin 3 and/or Pin 4 are
already populated, remove the terminal(s) using
Delphi Terminal Removal Tool #12094429 or a
Small Flat Watch Repair Screwdriver and isolate
with Electrical Tape.
Step 11: Remove both terminals from chassis
harness. Splice provided loose red wire to
chassis harness red wire and insert terminal
into pin position 3 on the white 22-pin radio
connector (Figure 1) until it clicks securely.
Step 12: Splice provided loose black wire to
chassis harness black wire and insert
terminal into pin position 4 on the white 22-
pin radio connector (Figure 1) until it clicks
securely.
Step 13: Connect White 22-pin Connector to
radio along with all remaining radio
connectors before reinstalling radio head
unit and all trim removed.
Step 14: Route supplied Chassis Harness
under carpet to the center console area.
CAUTION: Keep harness away from accelerator,
brake pedal, and parking brake assembly.
FLTW-7632 Instructions 9-1-15.doc
INSTALLATION
I NSTRUCTIONS
Step 15: Connect Power Harness male RCA
connector to Display Harness female RCA
connector.
Step 16: Using a vehicle specific service
guide/wiring diagram and a multi-meter
verify 12v Ignition power source. Red wire
of power harness connects to 12v+ Ignition
power and Black wire of power harness to
Black chassis ground nut or wire.
RECOMMENDED: Solder wires and cover with Heat
Shrink Tubing or use T-taps as an optional
connection method.
Step 17: Connect Chassis Harness to supplied
Power Harness RCA and power plugs.
Step 18: Use Wire Ties or Electrical Tape to
secure Chassis Harness and Jumper Harness
RCA and power connections.
Step 19: Coil any excess Chassis Harness and
secure it and the Jumper Harness to existing
vehicle wiring with Wire Ties or Electrical
Tape.
Page 3 of 4