DOEPFER Drehbank Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Equipamento de música DOEPFER Drehbank. DOEPFER Drehbank 8 páginas. Midi controller box

Snapshot Mode

Once the snapshot switch has been pressed the L.E.D. above it blinks rapidly. By pressing

the switch once again within a second a „Snapshot" will be sent and this is indicated by the

L.E.D staying lit (again for about a second). After this the L.E.D.s returns to bank indicator

mode.

Under normal operating the L.E.D. which indicates the Snapshot mode is switched off. For

that reason this L.E.D. ( top ) is also used to indicate Midi events.

The L.E.D. flashes for every activity on the Midi bus (both Midi In, and Midi Out).

Midi events are normally performed very quickly and therefore the flashing of the L.E.D. is

hardly noticeable. Turn a controller and watch the glow of the L.E.D.

The indicator also shows if a control knob is sending an event. Also you can see, if the

Drehbank

is receiving Midi data.(e.g.the receiving of information from the editor program.)

On the left of the unit you`ll find 3 black switches with the following functions:

As you will see the Drehbank unit has no ON button/switch. To activate the ROM presets

you must press a switch at the same time as you plug the power In (see the README.TXT

file).

The indicator above the pressed switch will not light up, but instead the other two indicators

will flash.

E.g., when turning the unit on you press switch 1 (the top switch), to select ROM preset 1.

The L.E.D. above that switch will not light up, but the other 2 L.E.D.s will light up. This

inverted indication system also goes for the recalling of the other presets.

This means that the Drehbank at that moment loads the ROM preset and will wait until you

release the switch.

After this the Drehbank returns to normal operation mode and switches to bank 1, the

L.E.D.s are now also in normal operation mode.

Now the Drehbank is ready to ROCK. ☺

The recalling of the ROM presets has no effect on the nonvolatile memory (EEPROM). The

preset that you loaded from the editor software into the nonvolatile memory still exists. To

activate it again you must turn the unit off and on again.

For each bank there is one switch and one L.E.D. indicator.

Simply select a bank by pressing either of the bank switches on the Drehbank

The

Drehbank will then activate the selected bank, which is indicated by the flashing of the

L.E.D. above the pressed switch.

To create a Snapshot you must first press the top switch (labelled snap). When the switch is

pressed for about a second the L.E.D. (that is otherwise inactive except for Midi activities)

blinks rapidly. Press the switch again within a second and a Snapshot will be sent, indicated

Short Manual

Page 5

Drehbank