DogWatch BIGLEASH Manual - Página 20

Procurar online ou descarregar pdf Manual para Produtos para animais de estimação DogWatch BIGLEASH. DogWatch BIGLEASH 20 páginas.

Adding A Second Receiver Collar (Dog 2)

Every transmitter comes with two dog-capability. Your transmitter is pre-set for use

with one dog but can easily be programmed for use with two dogs.

To use the BigLeash Remote Trainer with two dogs, you must have a receiver collar

for Dog 2. The receiver collar for Dog 2 comes with a bright orange collar strap so

that you can easily differentiate Dog 1 from Dog 2. As a reminder, the receiver for

the second dog has a small Dog 2 sticker on the back.

Programming Dog 2 Receiver

1. Before adding the second receiver to the transmitter, fully charge it for 3

hours.

2. Set the correction level on the transmitter to Level "2".

3. Hold down the Dog 2 button.

4. Continue to hold down the Dog 2 button while turning the new

receiver "on" by aligning the receiver next to the transmitter at the

alignment markers.

5. Continue to hold the receiver next to the transmitter. You will hear a

series of beeps.

6. When the series of beeps stops, move the receiver away from the

transmitter.

7. The second receiver is now programmed to the Dog 2 setting.

Using the Remote Trainer with Two Dogs

The Dog 1 and Dog 2 buttons allow you to change commands between the

two collars. The transmitter will store the most recent setting for each collar.

When working with two dogs, the display on the LCD screen will indicate if

the transmitter is set to send the signal to the collar on Dog 1 or Dog 2.

If you are working with Dog 1 and the Dog 2 icon comes on and starts to

flash, your transmitter is telling you to check the Dog 2 channel. It is letting

you know that either:

The Dog 2 battery is low, or

•

That Dog 2 has moved out of range.

•

When charging both collars at the same time, the receiver battery icon

displayed on the transmitter is specific to the collar for which the transmitter

is set (Dog 1 or Dog 2).