Acquaer PEP033 Manual do Proprietário - Página 3

Procurar online ou descarregar pdf Manual do Proprietário para Bomba de água Acquaer PEP033. Acquaer PEP033 6 páginas. Pedestal pump
Também para Acquaer PEP033: Manual do Proprietário (11 páginas)

Imprimir página

PIÈCES SCHÉMA

LISTE DES PIECES

La description

Numéro de pièce

corps de la pompe

base de la pompe

Arbre de transmission

boule flottante

interrupteur

impelleur

SAFETY INFORMATION

  A lways use a grounded outlet to attach the plug. A three-prong mating type receptacle is needed

for safe use. This should be in accordance with the National Electric Code and any additional

codes or laws required by your local government.

  T his unit is designed only for use on 115 volts (single phase), 60 Hz, and is equipped with an

approved 3-conductor cord and 3-prong grounded plug. DO NOT REMOVE THE GROUND PIN

UNDER ANY CIRCUMSTANCES. The 3-prong plug must be directly inserted into a properly

installed and grounded 3-prong, grounding-type receptacle. Do not use pump with a 2-prong wall

outlet. Replace the 2-prong outlet with a properly grounded 3-prong receptacle (a GFCI outlet)

installed in accordance with the National Electrical Code and local codes and ordinances. All

wiring should be performed by a qualified electrician.

  P rotect the electrical cord from sharp objects, hot surfaces, oil, and chemicals. Avoid kinking the

cord. Do not use damaged or worn cords.

CAUTION

    Y our pump has thermal over-load protection built in. The thermal overload protector will

automatically shut down the motor in an overheat situation. It will then reset itself once the motor

cools down. The pump will then work again. This overload protector is designed as a safety device

and it will fail after repeated use.

    F or best performance, it is recommended to connect the power cord directly to the grounded GFCI

outlet. If the use of an extension cord is necessary, always use a grounded waterproof type cord.

Never use longer than a 25-ft. cord that is lighter than 14/3 gauge.

    K eep all electrical connections away from wet and moist environments. Wet connections can

cause electrical shock resulting in personal injury.

    A LWAYS DISCONNECT THE POWER SOURCE BEFORE ATTEMPTING TO INSTALL, SERVICE

OR PERFORM MAINTENANCE ON THE PUMP. FAILURE TO DO SO MAY RESULT IN FATAL

ELECTRICAL SHOCK.

INSTALLATION INSTRUCTIONS

  1 .

  a . Insert the float rod through the hole in the switch.

b. Carefully slide the rubber grommet onto the float rod. NOTE: Use liquid soap to help slide the

grommet on the float rod.

c. Slide guide onto the float rod and attach it to the column.

d. Thread the float ball onto the float rod. You may need a set of pliers to prevent the rod from

turning.

e. Move the grommet up or down on the float rod to adjust the "turn on" position of the pump.

  S et your new pump in the bottom of the sump basin. The pump should be placed on a solid

foundation. Do not place pump directly on sandy or rocky surfaces. Sand and small stones may

clog or cause damage to your pump.

  M ake sure the float ball will move up and down freely

without coming in contact with the side of the sump pit.

Contact with the side of the sump pit may cause the

switch to malfunction. See as below.

GFCI Outlet

Switch

Grommet

Guide

Column

Float Rod

Check Valve

Float Ball