ASI 0388 Manual
Procurar online ou descarregar pdf Manual para Dispensador ASI 0388. ASI 0388 3 páginas. Vanity mounted automatic soap dispensing system liquid soap dispenser
Imprimir páginaVANITY MOUNTED AUTOMATIC SOAP DISPENSING SYSTEM LIQUID SOAP DISPENSER
1-1/2" DIA. [Ø38]
3-13/16"
[97]
SOAP TUBE
FRONT VIEW
SPECIFICATION
Vanity Mounted Automatic Soap Dispensing System Liquid Soap Dispenser shall dispense liquid soap having a pH in
range 7± 1.5 and within the viscosity range of 5–3000 cP (mPa•s) in stream cycles with volumes of approximately
0.034~0.051 oz (1~1.5 ml) of liquid soap during each activation when connected properly to control-pump module
Model № 0386 in appropriately configured system. Dispenser spout body shall be type 304 stainless steel alloy 18-8
and all exposed stainless steel surfaces shall be satin finish. Dispenser shall operate automatically from IR sensor that
shall activate dispensing when hands are placed in sensor zone. Sensor detection range shall be preset at 4-3/4" ± 1-
1/2" [121 ± 38] and shall self-compensate for lighting conditions. An indicator LED shall provide status notification
of user sensor detection. Unit shall mount on vanity deck up to 2" [51] thick through 1" Dia. [Ø25] hole minimum to
1-1/4" Dia. [Ø32] max. Soap supply shall be from Control Module (Model № 0386, provided with system) connected
to Vanity Mounted Top-Fill Tank (Model № 0387, provided when ordered with system) with capacity of 1.6 gal (6 L)
of liquid soap containing no abrasives or particulates. An Owner's Manual and Installation Guide (OM & IG) and
Mounting Template (MT) shall be provided with unit in carton.
Vanity Mounted Automatic Soap Dispensing System Liquid Soap Dispenser shall be Model № 0388 of
American Specialties, Inc., 441 Saw Mill River Road, Yonkers, NY 10701-4913
INSTALLATION
Install unit to counter top with washers and basin nut (supplied) into 1" Dia. [Ø25] hole located in counter top per
template or to suit site conditions. Connect soap supply tube from dispenser shank to fitting on top of control
module (Model № 0386, provided with system). Connect COM cable with multi-pin socket into control unit
inline cable connector.
OPERATION
Liquid soap is automatically dispensed when hands are placed in sensor zone. LED indicator flashes once to indicate
detection of object in sensor zone. See OM for complete maintenance and refilling instructions.
5-3/8" [137]
TOP RUBBER WASHER
STAINLESS STEEL
WASHER
RUBBER WASHER
BASIN NUT
SENSOR CABLE
LENGTH 18-1/2" [470]
SENSOR CABLE
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
1-1/2" DIA. [Ø38]
7/8" DIA. [Ø22]
2-3/4"
[70]
SOAP TUBE LENGTH 17" [432]
SIDE VIEW
MODEL №:
ISSUED:
REVISED:
ISOMETRIC
NOTE
ALL DIM'S INCH [MM]
ILLUSTRATION FOR REF ONLY AND NTS
0388
9 SEP 2020