ASI 0388 Manual - Página 2
Procurar online ou descarregar pdf Manual para Dispensador ASI 0388. ASI 0388 3 páginas. Vanity mounted automatic soap dispensing system liquid soap dispenser
Imprimir páginaVANITY MOUNTED AUTOMATIC SOAP DISPENSING SYSTEM LIQUID CONTROL MODULE
4-5/8" [117]
C L
3-5/32" [80]
43/64" [17]
C L
4-55/64"
[123]
C L
T-CONNECTOR
FRONT VIEW
SPECIFICATION
Vanity Mounted Automatic Soap Dispensing System Liquid Control Module shall operate L-pump to deliver soap
having a pH in range 7± 1.5 and within the viscosity range of 5–3000 cP (mPa•s) to spout Model № 0388 (supplied)
to dispense in stream cycles with volumes of approximately 0.034~0.051 oz (1~1.5 ml) of liquid soap during each
activation. Control Module activates when assembled with Vanity Mounted Automatic Liquid Soap Dispenser
(Model № 0388, provided with system). Control Module must be connected to Vanity Mounted Automatic Soap
Dispensing System Top-Fill Tank (Model № 0387, provided with system) with tubing (provided with system) and
must be powered by power adapter (Model № 72-ACA, provided). Alternatively, optional Battery Pack is available
(order Model № 0385-BP separately). Multiple Vanity Mounted Automatic Soap Dispensers can be assembled in
chain when one (1) Control Module is connected to Vanity Mounted Top-Fill Tank (Model № 0387, provided when
ordered with system) and each additional Control Module shall draw soap through supply tube (provided) connected
to T-connector making a supply chain of soap distribution and additional Model № 0388 Soap Dispensers are
installed to draw soap from each additional control module. An Owner's Manual and Installation Guide (OM & IG)
and Mounting Template (MT) shall be provided with unit in carton.
Vanity Mounted Automatic Soap Dispensing System Liquid Control Module shall be Model № 0386 of
American Specialties, Inc., 441 Saw Mill River Road, Yonkers, NY 10701-4913
INSTALLATION
Install unit under vanity top as per template or to suit site conditions. Connect soap supply tube from shank of
Liquid Soap Dispenser (Model № 0388, provided with system) to fitting on top of control module. Connect COM
cable with multi-pin socket into control unit inline cable connector. Connect soap supply tube into Top-Fill Tank
L-fitting or T-fitting of previous module in chain of multi-unit installation. Connect power supply (Model №
72-ACA or Model № 0385-BP) into DC-Power jack located on the side of the Control Module.
OPERATION
Control Module will operate automatically when hands are placed in sensor zone of Liquid Soap Dispenser (Model №
0388, provided with system). See OM for complete maintenance and refilling instructions.
C L
BASE PLATE
LIQUID SOAP PUMP
SENSOR WIRE
DC POWER SOCKET
CONTROL BOX ASSEMBLY
SHUT-OFF
VALVE-CONNECTOR
SOAP TUBE (SUPPLY
LINE, EITHER SIDE)
(47-1/4" [1200] LENGTH)
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
MODEL №:
ISSUED:
REVISED:
3-17/32" [90]
10-1/2"
[267]
SIDE VIEW
0386
9 SEP 2020
NOTE
ALL DIM'S INCH [MM]
ILLUSTRATION FOR REF
ONLY AND NTS
ISOMETRIC