BlueSky Mast AL350G Series Folha de referência rápida - Página 3

Procurar online ou descarregar pdf Folha de referência rápida para Sistemas de elevação BlueSky Mast AL350G Series. BlueSky Mast AL350G Series 6 páginas. Primary guying deployment

Imprimir página
38
Locate the 4 Primary Guy
Ropes with the red clips.
43
Make sure the cam lock is
LOCKED and lower the lift base
plate to the ground.
48
Repeat steps 43 - 47 until the
primary guy ropes go taut.
53
Raise the mast until the primary
guy ropes go taut. Incremental
guying may be required.
Do Not Duplicate, Alter, or Copy without the Express Written Consent
of BlueSky Mast, Inc. Copyright 2016 Allendale LLC All Rights Reserved
Quick Reference Sheet - Primary Guying
39
Remove the guy leader and clip
a primary guy rope to the round
hole on the primary guy ring.
44
Insert a center mast pole onto
the lift base plate.
49
Always monitor your guy wires
during deployment and use
Velcro Straps to secure cabling.
54
When the primary guy ropes go taut or if the mast begins to lean exces-
sively - Stop and Lock the Cam Lock. Now adjust all 4 PRIMARY GUY
ROPES and make sure the mast is straight and perpendicular.
AL350G Lift Series
DEPLOYMENT
40
Walk away from the mast and
unwind ALL of the guy rope off
of the guy handle.
45
Raise the center mast pole
until it nest together with the
mounting pole.
50
WARNING: If at any point the
mast begins to slip while the
cam lock is locked - STOP
Read Manual Before Use
Refer to detailed instructions in the
AL350G Lift Series Manual at all times
41
Clip the primary guy rope into
the top hole on the guy stake.
46
Make sure the castle cuts nest
firmly together and there is no
gold insert showing.
51
Use the 7/16 wrench provided
with the system to make adjust-
ments to the cam lock.
55
Adjusting the Primary Guy Ropes
Hold the rope in front of the guy handle and slide the handle back to
loosen or forward to tighten.
42
7 ft.
Slide the guy handle towards
the mast approx. 7 feet. Repeat
process on all 4 Guy Ropes.
1"
47
Release the cam lock and raise
until 1 inch is showing below the
cam lock. Lock the cam lock.
52
Tighten the nut on the cam lock
a quarter turn until slipping no
longer occurs.