Ambifuego KALIDO 73 Instruções de instalação, de utilização e de manutenção - Página 8

Procurar online ou descarregar pdf Instruções de instalação, de utilização e de manutenção para Lareira de interior Ambifuego KALIDO 73. Ambifuego KALIDO 73 15 páginas. Convector gas fire

Imprimir página

Closing the Glass Door.

1 Place the glass door in position over the studs on the heat exchanger making sure the
joint in the rope seal lies along the lower edge. Secure in position with the 2 nuts and 2
screws. Tighten evenly.

Installing The Decorative Frame.

1
Hook the decorative frame over the supporting lugs within the convector box.
C
OMMISSIONING
WARNING.
This appliance is fitted with a spillage monitoring system consisting of a flue
temperature switch. Should the chimney become blocked, the sensor will become
hot, and the appliance will go out. The installer must not attempt to adjust this
system, nor shall he put it out of operation. Should any part of this system need to
be replaced, only original manufacturers parts shall be used.
1
Before attempting to light the appliance the gas supply must be turned on by removing
the cap from the isolator fitting and unscrewing the plug all the way out. Replace the cap
making sure that the tab engages with the slot in the top of the plug. Tighten the cap
securely. Light the appliance in accordance with the instructions in the lighting section.

Briefing the User

1
Demonstrate the full operation of the appliance to the customer.
2
Inform the customer that all cleaning procedures should be carried out only when the
appliance is cold.
3
Leave these instructions with the customer.
4
Advice the importance of having the appliance serviced and the chimney checked for
clearance of combustion products on an annual basis.
S
M
ERVICE AND
AINTENANCE
BEFORE ANY SERVICING IS CARRIED OUT ISOLATE THE APPLIANCE FROM THE
GAS SUPPLY. AFTER REFITTING THE APPLIANCE, CHECK FOR GAS
SOUNDNESS AT ALL GAS JOINTS AND TEST FOR SPILLAGE.
This product may use fuel effect pieces containing Refractory Ceramic Fibre
(RCF). This material contains man-made vitreous silicate fibres. Excessive
exposure to these materials may cause temporary irritation to eyes, skin and
respiratory tract; consequently, it makes sense to take care when handling these
articles to ensure that the release of dust is kept to a minimum.
8