AMBIONAIR FLAME EF628 Manual de instruções de instalação e utilização - Página 5

Procurar online ou descarregar pdf Manual de instruções de instalação e utilização para Lareira de interior AMBIONAIR FLAME EF628. AMBIONAIR FLAME EF628 8 páginas. Electric fireplace insert with remote control

!

OPERATING INSTRUCTIONS

The firebox insert's main power "on/off" must be switched "on" before any of the control functions' (on the insert
and/or remote control) will operate. NOTE: The main switch does not have to be turned off when the insert
is not being used for brief time periods. If you are not planning to use your insert for an extended period of time
we recommend the main power "on/off" be switched off.
This firebox insert features conveniently separate controls for the flame effect and heat control. This feature
allows you to operate the unit in 2 different ways:
1.
As a full featured fireplace insert with both flame effect and heater operating simultaneously.
2.
As a visual effect with flame effect only.(i.e. no heating cycle)
NOTE: This firebox insert is not designed to operate in "heat" only mode without a flame effect.

USING THE REMOTE CONTROL:

1. MAIN POWER BUTTON: Press the "main power button" on
the firebox, the flame effect (only) will turn on. To turn the
firebox "off" press the "main power button" again.
2. DOWN LIGHT BUTTON: Press to turn night light on or off.
3. FLAME EFFECT: Press the flame button up or down arrow to
achieve
the desired effect. At one point it will shut off.
4. HEAT: Press the up or down arrow on the heat button to adjust the
temperature levels higher or lower.
5. TIMER: Set the timer to turn OFF in: 10min, 20min, 30min, 40min,
50min, 1H, 2H, 3H, 4H, 5H, 6H, 7H, 8H or, 9H.
6. EMBER EFFECTS: Press for desired ember dynamic effect in
automatic mode.
USING THE MANUAL CONTROLS
LOCATED ON THE FIREBOX
INSERT.
5
4
!
!
!
3
2
1
!
!
!
1. Main Power Button: When turned on the power
indicator light and flame indicator light are on and
brightness level show "4"
2. Control button for flame and brightness adjustment:
-
Flame comes from LED light board, and has 4
levels of brightness adjustment.
-
The 5W reflector motor, has and ON/OFF switch to
adjust with the flame.
-
The log light adjusts to 4 levels of brightness.
3. Heater button has 7 levels of temperature settings.
Hold down heater button for 10sec to convert "C" to
"F".
4. Down light button: Press to switch night light ON/OFF.
5. Effect button: Press to automate dynamic effects.
!
1
2
3
4
5
6