AMC IF16T Установка

Просмотреть онлайн или скачать pdf Установка для Датчики безопасности AMC IF16T. AMC IF16T 4 страницы. Pir curtain lens intrusion detector

Печатать страницу

FÜGGÖNY KARAKTERISZTIKÁJÚ MOZGÁSÉRZÉKELŐ

PIR CURTAIN LENS INTRUSION DETECTOR

1. INTRODUCTION

IF16T is a curtain pir sensor, can create a barrier of protection useful for doors and windows.

And it is possible set a delay system activation.

2. DELAY SYSTEM ACTIVATION FUNCTION (DIP4 - DIP5)

Turning ON the DIP introduces a time delay between the instant of the sensor detects the move-

ments and the instant at which trigger the alarm relay. After the first violation, the sensor will count

the set time, after this time and for more 10 sec. there will be some movement, turn in alarm, if after

the set time there will be no movements, the sensor will go into reset.

3. INSTALLING AND SETTING

The sensor is designed to be installed to protect the openings, for example between the window

and the shutter, or to doors and gates. Due to the high angle of coverage and the ability to rotate

the lens on the support of the pyroelectric, you can install it in different ways, from top to bottom or

on one side.

For the dip switch settings see the diagram below

DIP-SWITCH

DIP 1-6-7-8

not used

DIP 2

walk led OFF

DIP 3

2mt coverage

DIP 4

immediate alarm

DIP 5

immediate alarm

4. INSTALLATION AND CONNECTIONS

Choose a suitable location, mount the sensor using the turrets tear to get the tamper protection.

The cable can go from a tiny hole next to the terminals, or if the section is very large, you can switch

from the knock-out (see figure below)

Fixed base rear slide the cable through the holes selected, secure the board in its housing interlo-

cking and fix the cables into the appropriate terminals.Fix with screw the top.

In the figure at the end of manual, you can see different types of installation, in the center of the

window or on a side. The drawings are for guidance only, so you should always test the sensor.

5. WARM UP AND OPERATION

At start up the sensor needs a warm up time, this time is about 40''. There will be fewer violations

during this time is the faster entry into operational mode.

Operating without options: when the sensor is ready ,after the first violation, the waiting time for

second violation is a few seconds (5 sec. max).

Operation with delay times (dip 4 - 5): with the delay time set, you can access protected air wi-

thout giving alarm, so you can access the system without disarm. After this time, the sensor resets

without giving alarm. If after the set time for more 20seconds, the sensor detects movement still

give alarm.

www.amcelettronica.com

IF16T

OFF

walk led ON

3.5mt coverage

Delayed 30'' + 10'' (dip4 ON + dip5 ON = 1'30'')

Delayed 1' (you can add the time at 1'30"with dip)

IF16T

TELEPITŐ

INSTALLATION

installation instructions