Coalesse SW 1 Table Руководство - Страница 8

Просмотреть онлайн или скачать pdf Руководство для Внутренняя отделка Coalesse SW 1 Table. Coalesse SW 1 Table 11 страниц.

10.

Rest the other half (with the

larger domino and dowel holes) on

top of the cones.

11.

Make sure halves are in

alignment, then move the free half

at a slight angle so that the oversize

holes accept the dominoes / dowels.

12.

Push halves together until tight.

13.

Install a Zipbolt connector, snug

but not tight, into routs at all routed

locations. Place as deep as possible in

the pocket. Ensure that table edges

are flush at the joint (side to side).

Do not use rubber mallet to align

tops from side to side!

NOTE: After all Zipbolts are hand

tightened, fully tighten to 7.4-ft-lb torque.

DO NOT use impact drivers.

NOTE: If cones aren't properly located

with the cutouts, raise the center of

base to help align them.

ZIPBOLT CONNECTOR

Place as deep as possible

in the pocket.

Page 8 of 11

939500440 Rev E