Troubleshooting
Troubleshooting
Troubleshooting
Troubleshooting
Let's take a look at countermeasures against troubles which may occur during use of the printer.
Here, we will discuss errors indicated on the LCD, problems that might occur
Note
during direct printing from the digital camera, and problems that are also likely
to occur while using the Photo Viewer. If you cannot find the symptom
corresponding to a certain problem, refer to the
"A Message is Displayed on the LCD" on page 43
"Ink does not come out/ Printing is Blurred/ Colors are Wrong/ White Streaks" on
page 45
"Printed Surface is Scratched" on page 45
"Cannot Print Properly from the Digital Camera" on page 46
"An Error Message is Displayed While Using the Photo Viewer" on page 47
A Message is Displayed on the LCD
If a message is displayed on the LCD, take the corresponding countermeasure described below.
Message
No images.
Waste ink tank almost full.
Read-write mode enabled.
Failed to align print head
Cannot communicate with digital
camera.
Unsupported device connected.
Image data edited/processed on the computer should be printed from the computer, not
from the camera.
Press the Resume
Resume button to recover from the error.
Resume
Resume
You can print images for a while but you cannot print any more image when the waste ink
tank becomes full. Contact the Customer Care Center.
The memory card utility started on the computer has write-enabled the card slot. When
the card slot is write-enabled, the printer cannot print images.
When you have finished writing data to the card, select the read-only mode. For the
cancellation procedure, see "Setting up the Card Slot as the Memory Card Drive of the
Computer" on page 31.
Press the Resume
Resume button and follow the procedure below.
Resume
Resume
(1) Open the front cover and check if there is ink left. If there is no ink left, replace the ink
tanks. See "Replacing Ink Tanks" on page 36.
(2) Print the nozzle check pattern to verify that the print nozzles are clean.
See "Printing the Nozzle Check Pattern" on page 39.
(3) Move the printer so that the paper output is not in direct sunlight and try automatic
print head aligning again.
(4) If the error persists, adjust the print head manually on page 44.
Disconnect the camera connection cable, press the Resume
the cable once more.
The digital camera should be turned on automatically. If not, turn it on manually.
Disconnect the camera connection cable, press the Resume
the cable once more.
If the error is still unresolved, there is a possibility that you are using a digital camera or
digital video camcorder that is not supported by this printer.
Connect only digital cameras or digital video camcorders that are compatible with this
printer.
User's Guide
.
Try This
Resume button, and then connect
Resume
Resume
Resume button, and then connect
Resume
Resume
43
Печатать страницу