Aktakom AM-1171 Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Мультиметр Aktakom AM-1171. Aktakom AM-1171 11 страниц. Digital multimeter

Input Port: Measure the positive input terminal of voltage, frequency, resistance, capacitance, diode as well as

on-and-off test, and insert red meter pen.

7. 10A current input jack: Measure the positive input terminal of 10A shift AC/DC current, and insert red meter pen.

8. mA input port: Measure the positive input terminal of AC/DC.

9. COM input port: Measure the negative input terminal, and insert black meter pen.

Ⅵ. Other Functions

1. Automatic power off

After the meter is stopped for 15 minutes, it will cut off power automatically (power off), and then enter the dormant

(power off) state. The built-in buzzer will send out warning tone in one minute before it powers off. If you want to restart

power(power on), please press the power switch. If you want to cancel antomatic power-off, please press "REL" key over 2

seconds until the RS232 symbol appears. Meanwhile the "APO" symbol will be also turned off.

Ⅶ. Property

1. General features

1－1 Display mode: LCD

1－2. Maximum display: 5999.3 5/6 display automatic polarity display and unit display.

1－3. Analog bar. 30 times/sec, display of 61 analog bars.

1－4. Measurement mode: dual integration A/D conversion.

1－5. Sampling rate: About 3 time/s.

1－6. Over range: Display "OL"

1－7. Low voltage display: about 2.4v, the symbol

1－8. Working temperature: ：0～40℃

1－9 Storage temperature: -10～50℃, relative humidity <80%

1－10. Power: Two 1.5v batteries ("AAA" 7# batteries)

1－11 Volume (Dimensions): 185mm×91mm×49mm（Length*width *height）

1－12 Weight: About 410g (including battery )

2． Technical features.

2-1. Accuracy: ±（a% reading + d digits）, the ambient temperature for ensuring accuracy: 23±5℃, relative humidity <75%.

2-2. The warranty period of calibration is one year from ex-factory date.

Ⅷ. DC Voltage (DCV)

1．Press "AC/DC", select automatic measurement of DC voltge., and respectively plug in the red and black meter pens into

the terminals of "VΩHz"and"COM", as shown in the following diagram.

2 ．The initial state of the meter is the DC voltage automatic measurement mode, which shows the symbols of

"DC""AUTO""APO". Press "RANGE" is to select manual range mode; Press "MAX/MIN" once to show the Max

measurement value. Press "MAX/MIN" again to show the Min measurement value. Press "MAX/MIN" over 2 seconds is

to cancel the measurement of the MAX/MIN value.

3．Touch the measuring point with the meter measuring pen and connect it in parallel to the circuit being tested, and the

www.tmatlantic.com

displayed.

- 4 -