Canon AE-1 Руководство по процедурам установки - Страница 44

Просмотреть онлайн или скачать pdf Руководство по процедурам установки для Цифровая камера Canon AE-1. Canon AE-1 48 страниц.
Также для Canon AE-1: Начало работы (2 страниц), Руководство по эксплуатации (22 страниц), Руководство (42 страниц), Руководство (12 страниц), Руководство по эксплуатации (22 страниц)

2) Check the tilt of the puncher unit and the host ma-

chine.

4.2

Making Adjustments

<Finisher-AEl

Saddle Finisher-AE2>

Check to see if the gap between the top cover of the

puncher unit and the delivery cover of the host ma-

chine is 3 +/-I .5 mrn. Take measurements at two loca-

tions (front and rear); then, check to see that the

difference in the gap between the front and the rear is

1.5 mm or less. Moreover, check to see that the gap

running from top to bottom between the finisher and

the host machine is parallel when viewed from the

front.

3) If the heighthilt is correct, end the installation work

as instructed in "Installation after ChecksIAdjust-

ments" and later. Otherwise, make adjustments as

instructed in "Adjusting the HeighdTilt."

4.2.1 Adjusting the HeightITilt

If the difference in height between the puncher unit

and the host machine or the tilt is not as indicated,

make adjustments as follows; be sure to adjust the

height before adjusting the tilt:

Preparing for Adjustment

In the case of the Finisher-AEl, you may need to

remove the auxiliary ring and the rear foot cover of

the finisher before adjusting the height; be sure to

remove the auxiliary ring without disconnecting the

finisher from its host machine to prevent the finish-

er from tumbling over.

<Finisher-AE 1 >

1) If the height at the rear must be corrected, remove

the auxiliary ring and the left rear foot cover.

Remove the four screws [I], and detach the auxilia-

ry ring [2]. Remove the screw [3], and detach the

left rear foot cover

[4].

2) Remove the three screws, and detach the front cov-

er. (Skip this step if it has already been removed.)