Astivita ASEDW Руководство пользователя - Страница 4

Просмотреть онлайн или скачать pdf Руководство пользователя для Посудомоечная машина Astivita ASEDW. Astivita ASEDW 6 страниц. Domestic dishwasher

Печатать страницу

Detergent and Rinse Aid

Detergent

Detergent specifically intended for use with dishwashers must

be used. The dispenser must be refilled before the start of each

wash cycle following the instructions provided in the "Wash Cycle

Table". The detergent dispenser is located on the inside panel of

the door.

Loading the detergent

To open the "A" cover on the dispenser, press the "B" button.

The detergent for the wash cycle should be poured into the "C"

compartment.

After the detergent has been placed in the dispenser, close the

cover and press down until it clicks into place.

Notice: To enable the cover to close, remove any ex-

cess detergent from the edges of the dispenser.

Rinse Aid

This product makes dishes sparkle and helps them to dry with-

out spotting. The dispenser is located on the inside panel of the

door and should be filled after approx every 80 wash cycles (or

when the "low rinse aid" indicator light comes on for those mod-

els with this feature).

Loading the Rinse Aid

Regardless of the type of detergent dispenser installed on your

appliance, you must proceed as indicated below when loading

the rinse aid.

To open the dispenser, turn the "C" cap in an anti-clockwise

direction and then pour in the rinse aid, making sure not to overfill.

The amount of rinse aid used for each cycle can be regulated by

turning the "F" dose adjustor, located beneath the "C" cap, with

a screwdriver. There are 6 different settings; the normal dosage

setting is 3.

Important

Proper dosage of the rinse aid improves drying.

If drops of water remain on the dishes or spotting occurs,

the dosage adjustor should be turned to a higher setting.

If the dishes have white streaks, turn the dosage adjustor

to a lower setting.

.3.

Troubleshooting

If the dishwasher does not function or does not function properly.

Before calling for assistance, check to see what can be done

first: have you forgotten to press one of the buttons or to per-

form an essential operation?

The Dishwasher Does Not Start

Have you checked whether:

- the plug is pushed into the socket correctly;

- the power is on in the house;

- the door is closed properly;

- the ON-OFF switch is on "ON";

- the water supply is turned on.

The Dishwasher Does Not Fill With Water

Have you checked whether:

- the water is turned on and the hose is connected properly;

- the water supply to the house is on and has sufficient pressure;

- the water supply hose is crimped or bent;

- the filter in the water supply hose is clogged.

The Dishes Are Not Clean

Have you checked whether:

- Dishwasher was loaded properly. Jets of water could not reach

all parts of the dishes, etc;

- Too many items in the rack;

- Items in the rack were touching each other;

- Not enough detergent was added to dispenser;

- Selected wash programme was intensive enough;

- Rotation of spray arm was obstructed by dish, etc;

- Nozzles in spray arm are blocked by remnants of food;

- Coarse or fine filter or microfiller is blocked;

- Filters have been incorrectly fitted;

- Drain pump is jammed;

The Dishwasher Does Not Drain

Have you checked whether:

- the drain hose is crimped or bent.

Lime Deposits or a White Film Form on the Dishes

Have you checked whether:

- the rinse aid dosage is correct.

Error Messages

The dishwasher is equipped with a safety system that is able to

detect operating problems and malfunctions. These malfunctions

are signalled by the rapid blinking of one of the "M" program LEDs.

Only in the case where the indicator light for the soak cycle (see

table for cycles) blinks rapidly should you cancel the cycle as

described in the section entitled, "Changing a Cycle while Under-

way." Then check to make sure that there is water in the mains

and that the tap is turned on. If the problem continues, call for

technical assistance, indicating which light was flashing.

If any of the other indicator lights begin to blink rapidly, turn off

the appliance and call for technical assistance, advising which

lights were flashing.

If, despite all these checks, the dishwasher still does not function

and/or the problem persists, contact the nearest authorised ser-

vice centre and provide them with the following information:

- the nature of the problem;

- the model number AND

serial number, which are on the plate located

on the side of the inner part of the door.

Never call on unauthorised technicians and refuse to

allow parts to be installed that are not original spare

parts.

.8.