Astonica 50100765 Руководство по эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Внутренняя отделка Astonica 50100765. Astonica 50100765 2 страницы. Stone ridge swivel rocker

Печатать страницу
PARTS　 LIST
ITEM
A
Chair Frame
B
Swivel Base & Rocker Assembly
C
5/16＂ X25MM Bolt
D
8.5X2.0MM Spring Washer
8.5X1.5MM Washer
E
F
5/16＂　
Nut
G
Metal plate
H
Hex Wrench-1
I
Hex Wrench-2
Parts　 Detail
B
A
G
Carefully　 remove　 the　 contents　 from　 the　 package．　
attempt　 to　 use　 the　 product　 until　 they　 have　 been　 obtained　 and　 correctly　 installed．
Step 1: Identify all parts packed in carton against the parts list. Remove all protective materials.
Place parts on a non-abrasive surface to avoid scratching.
Step 2: Place the swivel base (with rocker assembly) on a flat, solid surface. Make sure the
rocker assembly is positioned all the way into the base. It may have shifted or vibrated
out during shipment.
Step 3: Important: We recommend 2 people work together to assemble the chair. Note the
arrow labels on the "U" bar and the rocker assembly. Also note the horseshoe shape of
the rocker plate. Point the open end of the horseshoe away from you. The arrows on
the rocker assembly should be pointing towards you. Set the chair frame on the rocker
assembly with front of the seat facing you and the arrows on the "U" bar pointing
towards you ( See diagram). This is very important for a safe, balanced rocking motion.
If chair frame has been properly positioned on the rocker assembly, all arrows on
the "U" bar and rocker assembly will be pointing in the same direction.
Step 4: Critical Step: The two metal plates must be installed in the proper location. Read this
step and carefully examine the diagram. Guide the bolts and washer through the holes in
the "U" bar, through the holes in the steel spring plate, through the hole in the metal plate,
beneath the steel spring plate, add a spring washer and a nut to each bolt as shown in the
diagram. Hand tighten nuts 3-4 revolutions only. Repeat the same procedure on the
other side.
DESCRIPTION
QUANTITY
C
D
E
F
H
I
If　 any　 parts　 are　 missing　 do　 not
１
CAUTION: Failure to place metal plates under the rocker plates and above the "U"
1
bar exactly as shown in diagram will cause the bolt heads and nuts to damage the
1
structure of the rocker plates and the "U" bar. Damage due to over tightening of
4
bolts or improper assembly could cause injury and may void your warranty.
4
Step 5: Tighten all nuts and bolts with the hex wrenches provided. Do not over tighten.
Remove arrow labels from "U" bar and rocker assembly.
4
Step 6: Your chair should be ready for use. If your chair is not rocking properly, double-check
４
your assembly procedure, especially Step 3. If the chair rocks too far forward to or is
2
difficult to rock backwards, you have probably installed the seat frame backwards on the
1
rocker assembly. If you need further assistance.
1
Figure　 1
STEEL SPRING PLATE
ROCKER ASSEMBLY
SWIVEL BASE
NOTE：　
ASSEMBLY　 INSTRUCTIONS
FOOT CAP
This　 product　 is　 intended　 for　 residential，　
２
BOLT
WASHER
"U" BAR
METAL PLATE
SPRING WASHER
NUT
non－ commercial　 use．