Astonica 50100765 Інструкція з експлуатації - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Внутрішнє оздоблення приміщень Astonica 50100765. Astonica 50100765 2 сторінки. Stone ridge swivel rocker

Друкувати сторінку

PARTS　 LIST

ITEM

Chair Frame

Swivel Base & Rocker Assembly

5/16＂ X25MM Bolt

8.5X2.0MM Spring Washer

8.5X1.5MM Washer

5/16＂　

Nut

Metal plate

Hex Wrench-1

Hex Wrench-2

Parts　 Detail

Carefully　 remove　 the　 contents　 from　 the　 package．　

attempt　 to　 use　 the　 product　 until　 they　 have　 been　 obtained　 and　 correctly　 installed．

Step 1: Identify all parts packed in carton against the parts list. Remove all protective materials.

Place parts on a non-abrasive surface to avoid scratching.

Step 2: Place the swivel base (with rocker assembly) on a flat, solid surface. Make sure the

rocker assembly is positioned all the way into the base. It may have shifted or vibrated

out during shipment.

Step 3: Important: We recommend 2 people work together to assemble the chair. Note the

arrow labels on the "U" bar and the rocker assembly. Also note the horseshoe shape of

the rocker plate. Point the open end of the horseshoe away from you. The arrows on

the rocker assembly should be pointing towards you. Set the chair frame on the rocker

assembly with front of the seat facing you and the arrows on the "U" bar pointing

towards you ( See diagram). This is very important for a safe, balanced rocking motion.

If chair frame has been properly positioned on the rocker assembly, all arrows on

the "U" bar and rocker assembly will be pointing in the same direction.

Step 4: Critical Step: The two metal plates must be installed in the proper location. Read this

step and carefully examine the diagram. Guide the bolts and washer through the holes in

the "U" bar, through the holes in the steel spring plate, through the hole in the metal plate,

beneath the steel spring plate, add a spring washer and a nut to each bolt as shown in the

diagram. Hand tighten nuts 3-4 revolutions only. Repeat the same procedure on the

other side.

DESCRIPTION

QUANTITY

If　 any　 parts　 are　 missing　 do　 not

１

CAUTION: Failure to place metal plates under the rocker plates and above the "U"

bar exactly as shown in diagram will cause the bolt heads and nuts to damage the

structure of the rocker plates and the "U" bar. Damage due to over tightening of

bolts or improper assembly could cause injury and may void your warranty.

Step 5: Tighten all nuts and bolts with the hex wrenches provided. Do not over tighten.

Remove arrow labels from "U" bar and rocker assembly.

Step 6: Your chair should be ready for use. If your chair is not rocking properly, double-check

４

your assembly procedure, especially Step 3. If the chair rocks too far forward to or is

difficult to rock backwards, you have probably installed the seat frame backwards on the

rocker assembly. If you need further assistance.

Figure　 1

STEEL SPRING PLATE

ROCKER ASSEMBLY

SWIVEL BASE

NOTE：　

ASSEMBLY　 INSTRUCTIONS

FOOT CAP

This　 product　 is　 intended　 for　 residential，　

２

BOLT

WASHER

"U" BAR

METAL PLATE

SPRING WASHER

NUT

non－ commercial　 use．　