Door Controls DC One Руководство по установке - Страница 5

Просмотреть онлайн или скачать pdf Руководство по установке для Система открывания дверей Door Controls DC One. Door Controls DC One 20 страниц. Automatic sliding door retrofit drive assembly

Печатать страницу

WIRING OF ACCESSORIES

Complete all wiring. Refer to the wiring diagrams in Sections 11 and 18. Be sure to complete the wiring for any accessories that



may be required as well:

•

DRIVE BELT AND BRACKET INSTALLATION

Upon completion of all wiring, the drive belt, related brackets and idler pulley may be installed. Refer to the detailed dimensions



drawing that came with the package to determine all mounting locations. When complete, install the drive belt and tension to

result in approximately 1" to 2" deflection overall up and down at the center of the greatest span between clamp and pulley. The

belt may need to be cut to the correct length. Use a strong pair of wire cutters to make a clean cut.

Check to make sure there are no wires that could be potentially caught by the moving parts. With the belt installed and tensioned,



move the doors manually to their full open and then full closed position and ensure that they slide without binding or obstruction.

CONNECTING POWER

Connect and apply main power to the control.



Perform a factory reset – Refer to Sections 12 and 13.



Press the TEST button on the DC One control to trigger an activation cycle.



When the learn cycle is complete, normal operation will resume according to default values set in the control. Fine-tuning of the



control may be necessary at this point. Other than door handing and breakout polarity, the most common adjustments are for

speed, force and time. Although there are more adjustments if needed. See Sections 12 & 13 for further instructions.

WALK TEST

Check all functions to ensure proper operation



REMEMBER – Even if a door is designated for 1-way traffic, a secondary activation sensor is still required at the side not intended



for approach. The activation zone must extend to at least 24" out from the face of the door

With the door switch off, make sure the doors are fully closed. Check alignment of doors for proper weather-seal and ensure



that door locks properly

Use walk-test aides such as the dimensional mat shown below, to help outline key distances for testing sensor patterns



DC One V3 Installation Manual

M-0015 REV 06222017 P10

Activation Sensors

Safety Sensors

Safety Beams

On-Off Switch

Emergency Breakout Switch

Electric Carriage Lock (accessory)

Reduced Opening Switch (accessory)

1-Way Switch (accessory)

Page 3 of 15